Hi, it looks that way. I am not sure what it is, but, it looks like my it systems are breaking-down one by one. I lost the screen on my Mac, netbook is dead, my son's computer is started making funny noises etc. I am watching with interest to see where it takes me! Thank you Ali _____ From: access-uk@xxxxxxxxxxxxx [mailto:access-uk@xxxxxxxxxxxxx] On Behalf Of Mobeen Iqbal Sent: 14 January 2015 22:10 To: access-uk@xxxxxxxxxxxxx Subject: [access-uk] Re: NC10 hi. it sounds like a more serious fault in that case. it could be a graphics system failear, issues with the CPU, or a failed inverter. without seeing it it would be very difficult to comment... all the best, Mo. On 14/01/2015 21:38, Ali wrote: Hi, I do not think it has anything to do with the memory compatibility, as it does not start up with the original memory module is re-installed. There is a memory compartment door where the ram is accessed. Thank you Ali _____ From: access-uk@xxxxxxxxxxxxx [mailto:access-uk@xxxxxxxxxxxxx] On Behalf Of Mobeen Iqbal Sent: 14 January 2015 21:23 To: access-uk@xxxxxxxxxxxxx Subject: [access-uk] Re: NC10 hi. if its completely black the memory's probably incompatible. are you sure you bought the right specification of DDR memory for your netbook? there are a lot of varients/brands you can choose from. the NC10 as far as i can remember you have to strip down to get to the ram slot, or does yours have a door on the back? be careful how you put it back together and make sure your screen cables and components are seated correctly. all the best, Mo. On 14/01/2015 21:15, Ali wrote: Hi, nothing at all, it is a black screen. Thank you Ali _____ From: access-uk@xxxxxxxxxxxxx [mailto:access-uk@xxxxxxxxxxxxx] On Behalf Of Ibrahim Gucukoglu Sent: 14 January 2015 21:07 To: access-uk@xxxxxxxxxxxxx Subject: [access-uk] Re: NC10 Hi Ali. Are there any messages displayed on screen? If the memory has not been installed correctly, there will be an error from the BIOS and Windows will not boot. All the best, Ibrahim. From: Ali <mailto:alpot77@xxxxxxxxxxxxxx> Sent: Wednesday, January 14, 2015 7:18 PM To: access-uk@xxxxxxxxxxxxx Subject: [access-uk] NC10 Hi all, I just bought a 2gb RAM for my NC10. I replaced the old 1gb with this one. However, the netbook does not turn on. I changed the ram back to the original 1gb module still the same. The hard drive starts spinning but nothing happens. Does anyone have any idea what went wrong? Is there a reset button or something I can reset the unit? Thank you Ali