Hello, I need to set the paper length on an everest embosser. A4 is 295 CM or thereabouts i think. The value key increases the value up to about five hundred, but doesn't wrap back to it's starting value. How do I get the value to decrease when it has reached it's maximum? would I use 295 by 210 CM for a4 paper? I do not see a reference for reducing these values in the manual Thanks for any assistance with this. . Many thanks. Joe Paton ** To leave the list, click on the immediately-following link:- ** [mailto:access-uk-request@xxxxxxxxxxxxx?subject=unsubscribe] ** If this link doesn't work then send a message to: ** access-uk-request@xxxxxxxxxxxxx ** and in the Subject line type ** unsubscribe ** For other list commands such as vacation mode, click on the ** immediately-following link:- ** [mailto:access-uk-request@xxxxxxxxxxxxx?subject=faq] ** or send a message, to ** access-uk-request@xxxxxxxxxxxxx with the Subject:- faq