Below is the requirement for a arduino project.
Reply here or offline to me, if anyone is interested in doing this project.
Requirement:
Geophone sensor's parameter should be checked
Model no: SM24
This sensor is used for oil & gas seismic exploration work. Ten geophone
are connected in series.
sensor has inherent characteristics is given below:
1. Coil resistance : 270 ohm or 2701 for ten geophones
2. Damping. : 0.698
3. Sensitivity. : 210.2 volts/metre/second
4. Natural frequency. : 10Hz
5. Distortion. : 0.1%
6. Coil impedence : 7138 ohm for ten geophone
These parameter is to be analysed with Ardiuno board.
--
Regards,
T.Shrinivasan
My Life with GNU/Linux : http://goinggnu.wordpress.com
Free E-Magazine on Free Open Source Software in Tamil : http://kaniyam.com
Get CollabNet Subversion Edge : http://www.collab.net/svnedge