Actually it did and thank you Denver Dale -----Original Message----- From: jawsscripts-bounce@xxxxxxxxxxxxx [mailto:jawsscripts-bounce@xxxxxxxxxxxxx] On Behalf Of Andrew Hart Sent: Friday, October 31, 2014 2:30 PM To: jawsscripts@xxxxxxxxxxxxx Subject: [jawsscripts] Re: using the use function It's not as straight forward as that. While JAWS loads the jsb file by inserting the functions and scripts it contains onto the call stack, it does not load any key bindings from the accompanying jkm file. It is necessary to manually add keystrokes to the jkm file of the application using the jsb file. However, if the jsb file masks functions/scripts in the default scripts and default keystrokes exist for these, then it should just work since the default keystrokes will pick up the new functions off the call stack. However, not that if the application script file has scripts/functions with the same names as any of those in the jsb file being used, then the application-specific scripts/functions will take precedence. I hope that made some sense. Hth, Andrew. On 31/10/2014 17:20, Dale Alton wrote: > Hello all, > > I am curious about the use function. I tried inserting it into a file I have > at work and I don't think I did it correcly. I was using the notepad.jsb as > the test file. And my main data base as where I was inputting it. All I > did was put use "notepad.jsb". It didn't work. Aren't I suppose to be able > to use the keystrokes from my notepad.jsb? any additional help would be > appreciated. > > __________ > > View the list's information and change your settings at > http://www.freelists.org/list/jawsscripts > > > __________ View the list's information and change your settings at http://www.freelists.org/list/jawsscripts __________� View the list's information and change your settings at http://www.freelists.org/list/jawsscripts