[opendtv] Re: Fox stations disappear ... strange reason
- From: "John Willkie" <johnwillkie@xxxxxxxxxxxxx>
- To: <opendtv@xxxxxxxxxxxxx>
- Date: Wed, 21 Nov 2007 09:10:27 -0800
Sounds like tropospheric ducting and good, old-fashioned 'non-working' 8-VSB
coming through from afar. You should be able to find the station on the
FCC's web site; it was behind the channel 26 Fox signal.
John Willkie
-----Mensaje original-----
De: opendtv-bounce@xxxxxxxxxxxxx [mailto:opendtv-bounce@xxxxxxxxxxxxx] En
nombre de Doug McDonald
Enviado el: Wednesday, November 21, 2007 8:47 AM
Para: opendtv@xxxxxxxxxxxxx
Asunto: [opendtv] Fox stations disappear ... strange reason
Last night I could not get any of our three Fox TV stations.
We were having a cold front come in from the west. One station
is 68 mile west, 1 MW, 1300 foot tower. One is 45 miles NW,
1 MW, 800 foot tower, over a small hill. One is 23 miles east,
300 kW, 800 foot tower, over a small hill. All are usually
receivable with small (3-6 dB) signal margin.
I have a permanently installed spectrum analyzer.
Last night the two westerly stations were too weak, apparently due
to the signal being less-than-usually bent down by atmospheric
refraction.
The easterly one was a bit (3 db) higher than normal. BUT ...
about 1.5 MHz below the top of the channel was an interfering
apparently CW signal. It was about 6 dB higher than the ATSC
carrier. I could not tell if it were modulated; even at 30 kHZ BW it
seemed to be pretty much CW, at 3 kHZ it was too noisy to tell.
WTF????? !@$@#$^#^????????????
What is a CW carrier doing at that frequency? This is Ch. 26. There
is a digital station on 25 which is 120 miles east of us and
sometimes comes in, it was in nicely last night, but unreceiveable
because of a co-channel ordinary NTSC.
But the interference on Fox 26 was NOT NTSC! What was it? I worried
about harmonics in my preamp, but the interference was
there with the antenna directly into the spectrum analyzer.
Doug McDonald
----------------------------------------------------------------------
You can UNSUBSCRIBE from the OpenDTV list in two ways:
- Using the UNSUBSCRIBE command in your user configuration settings at
FreeLists.org
- By sending a message to: opendtv-request@xxxxxxxxxxxxx with the word
unsubscribe in the subject line.
Other related posts: