Hi, Fanmail from Bert: > Look at what Jeroen has been brewing all this time. > Just the type of product that I've been harping about. All standards, > non-CRT, HD by default, roll your own variant, meant for the mass > market. ;-) Though I must admit that at least the first generation of "Viper2" for the "Jaguar" platform was very much designed with CRTs in mind. We thought that 1080i @ 81 MS/s output rate was the ceiling. :-( The memory based scaler contains some work of mine, and I was involved in several generations of the input and output processors where the basic image enhancements are being done. But this was mainly IP re-use, so I should not claim much credit for that. Much more work has gone into the design of the software stack than into the hardware design. You do not want to know how many manyears that has cost. And even if you did, I'm not gonna tell ya... Best regards, -- Jeroen +-------------------------------+------------------------------------------+ | From: Jeroen H. Stessen | E-mail: Jeroen.Stessen@xxxxxxxxxxx | | Building: SFJ-5.22 Eindhoven | Deptmt.: Philips Applied Technologies | | Phone: ++31.40.2732739 | Visiting & mail address: Glaslaan 2 | | Mobile: ++31.6.44680021 | NL 5616 LW Eindhoven, the Netherlands | | Skype: callto:jeroen.stessen | Website: http://www.apptech.philips.com/ | +-------------------------------+------------------------------------------+ ---------------------------------------------------------------------- You can UNSUBSCRIBE from the OpenDTV list in two ways: - Using the UNSUBSCRIBE command in your user configuration settings at FreeLists.org - By sending a message to: opendtv-request@xxxxxxxxxxxxx with the word unsubscribe in the subject line.