You can build engines with that thing. Cut out thin aluminum sheets, stack on
top of each other, heat to about 800 to 1000 deg F in a oven. The sheets
sinter and become a 3D part. Before making parts, be sure do some trial runs
to determine the best temperatures.
Can make a wide variety of 3D shapes using this technique.
Rick Wills
From: arocket-bounce@xxxxxxxxxxxxx <arocket-bounce@xxxxxxxxxxxxx> On Behalf Of
roxanna Mason
Sent: Monday, 30 March, 2020 5:53 PM
To: arocket@xxxxxxxxxxxxx
Subject: [AR] Re: Hyperganic uses AI to design a 3D-printed rocket engine
It's completely adjustable from 1 watt to full power. just like your car can
idle or kick into passing lane. Usually the problem is too little power.
No where will a new 1KM single mode single phase fiber laser be found for under
$20.
On Mon, Mar 30, 2020 at 12:43 PM Joe Bowen <joe.b.bowen@xxxxxxxxx
<mailto:joe.b.bowen@xxxxxxxxx> > wrote:
Yea, I was sort of kidding. A 1KW fiber laser would be way to much for my
current setup, but it's fun to dream sometimes. But I'm pretty sure I'd end up
with a hole in my basement and a stupid electricity bill if I tried something
like that.
Joe
On Mon, Mar 30, 2020 at 1:33 PM roxanna Mason <rocketmaster.ken@xxxxxxxxx
<mailto:rocketmaster.ken@xxxxxxxxx> > wrote:
Yes Joe but it's a bit more than a 40W CO2 but certainly less than an
equivalent CO2 or YAG, I got a good deal and still under warrenty.
On Mon, Mar 30, 2020 at 12:30 PM Joe Bowen <joe.b.bowen@xxxxxxxxx
<mailto:joe.b.bowen@xxxxxxxxx> > wrote:
"I have a brand new 1KW fiber laser available, anyone?"
are you offering? that would be a nice upgrade from my current 40W co2
cutter/engraver.
Joe
On Mon, Mar 30, 2020 at 1:28 PM ken mason <laserpro1234@xxxxxxxxx
<mailto:laserpro1234@xxxxxxxxx> > wrote:
The concept is awesome, the design, funky, why the thick walls and 'excessive'
passages? Looks heavy even if aluminum, CRS even worse.
But when I saw 3D printing tech 10 years ago I wondered how long it would be
before the first bi-prop. Rocket Lab has certainly kicked ass!
I have a brand new 1KW fiber laser available, anyone?
On Mon, Mar 30, 2020 at 6:19 AM Joe Bowen <joe.b.bowen@xxxxxxxxx
<mailto:joe.b.bowen@xxxxxxxxx> > wrote:
https://www.dezeen.com/2020/03/30/hyperganic-ai-rocket-engine-3d-printed/ ;