Scott, Yes, once a new route is recalculated, the old points are thrown out. The problem in a moving vehicle is that you continue to move while the GPS is recalculating from a previous position. In these situations, it is best to either stop until the route is calculated or turn automatic recalculation off and wait until you are at a standstill to try another calculation manually. Mike At 08:12 AM 5/3/2006, you wrote: >Good morning all: >I wonder if anyone has any ideas concerning the following situation. >Last night before leaving home, I created an automatic route from my >home in Silver Spring, MD to downtown Washington, DC (about 6 miles). >The cab driver took an alternate route (probably more direct than the >automatic route which the software created). I had good coverage with 8 >satellites in view. >The software tried to recalculate the route a couple of times, but the >result was very unsatisfactory. Although my actual position was >announced, the system also announced how far away I was from the >waypoints contained in my pre-defined route. This was very confusing, >and I finally exited the program and reopened it in order to hear only >my position in real-time. How does the vehicle route recalculation >feature work? I would have thought that as soon as a off-route status >was detected, the system would have recalculated a new route with my >current gPS position as the starting point and would ignore the >previously defined route as no longer relevant. > >Any suggestions would be appreciated. > >Thanks. >Scott > > >Scott Marshall >Designated Federal Officer >Consumer Advisory committee >Federal communications commission >202-418-2809 (office) >202-744-4661 (wireless) >202-418-2809 (TTY/TDD via relay) >Email: scott.marshall@xxxxxxx > >***Non-public; for Internal Use Only*** > >