Scott, It could be that your file was corrupted when you turned off your unit in the middle of it being saved. Try recording a new point and see if that fixes it. If not, you should delete the file from the maps folder and start over. Mike At 10:32 AM 5/20/2006, you wrote: >Hello all: >Using version 3.5 with Keysoft 7 and an MPower, I get the following error >message when I try to edit my user poi file: "exception command: 398 at >20153". Since I am a new user, my user poi file is small: only 12 pois. I >have tried an ordinary reset a couple of times, but still get the same error >message when I run the program and try to edit the user poi file. Although >I'm not sure about this, I think I may have accidentally turned off my unit >last night without first exiting the application. >Any suggestions would be appreciated. > >Scott >