Mike: For the benefit of everyone on the list, I took your suggestion and my user poi file was recovered after saving a new poi. Thanks. Scott -----Original Message----- From: gps-talkusers-bounce@xxxxxxxxxxxxx [mailto:gps-talkusers-bounce@xxxxxxxxxxxxx] On Behalf Of Michael May Sent: Saturday, May 20, 2006 8:10 PM To: gps-talkusers@xxxxxxxxxxxxx Subject: [gps-talkusers] Re: Editing user poi file error message Scott, It could be that your file was corrupted when you turned off your unit in the middle of it being saved. Try recording a new point and see if that fixes it. If not, you should delete the file from the maps folder and start over. Mike At 10:32 AM 5/20/2006, you wrote: >Hello all: >Using version 3.5 with Keysoft 7 and an MPower, I get the following >error message when I try to edit my user poi file: "exception command: >398 at 20153". Since I am a new user, my user poi file is small: only >12 pois. I have tried an ordinary reset a couple of times, but still >get the same error message when I run the program and try to edit the >user poi file. Although I'm not sure about this, I think I may have >accidentally turned off my unit last night without first exiting the application. >Any suggestions would be appreciated. > >Scott >