Hi Robert, I know this is probably obvious, but since I've tripped over the obvious things myself more than once maybe somebody else does too. <smile> AFter you first turn on the MPower you need to wait 5 to 10 seconds for bluetooth to start up, even if you had it on when you shut down the MPower. Based on some other bluetooth devices I have around here, I'll bet the same holds true for the Holux. So, be sure you leave that little extra time before you attempt to start gps. If you're already doing this then maybe someone else such as Carl will have ideas. Don On Mon, 08 May 2006 16:51:44 +1200, robert stigile wrote: Hello all, I am looking for some suggestions for a problem I seem to have. I cannot seem to keep the pairing with my Holux receiver. I thought that once it was paired, all I would have to do, is turn on the receiver and the braillenote, press n and then g. Well, if I do that, it says bluetooth not detected. I either have to go to the bluetooth connection, and pair the receiver everytime I turn it on, or at least, go to the bluetooth settings, and activate activesync. I was told that I might want to try reinstalling keysoft, and I did this, and it did not help. I had performed a reset, so I knew I had to go and repair, so I did this, and had the gps working great. So, then about 2 hours later, I turned the braillenote on, pressed n and then g, thinking it would just go into the gps menu, but it told me that bluetooth was not detected, so I tried going to the connections and said no to search for bluetooth and then I pressed enter on activesync, and went back to the gps menu, and it still said bluetooth not detected, so I had to go back to the bluetooth and pair it. If anyone has any suggestions as to how I can fix this, I would very much appreciate it. Thanks, Robert __________ NOD32 1.1525 (20060508) Information __________ This message was checked by NOD32 antivirus system. http://www.eset.com