Robert, With Keysoft 7.0 here is what you should expect with Bluetooth connections. Once a Bluetooth device has been paired it should stay paired until a Hard reset dots 4,5,6 or j,k,l, or a service reset. If a normal reset has been done you will have to activate the Bluetooth device as the reset resets all Bluetooth active status. I have noticed that in a very few cases after resets that the Bluetooth is set off. I am not sure why this is occurring, but it is easy to check. Once the Bluetooth device is paired and active you should be able to return to the main menu and start GPS, it best to wait a few seconds after changing the Bluetooth device status. The only other cause of not connecting is a low battery state or the device is not on. On the Holux receiver you may want to have someone take a look at the status of the center led. This should be flashing blue every one second when not connected or waiting for a connection. When connected this blue led will be flashing blue every three seconds. Also check that the right led is not red which indicates a low battery. If all of the above are correct you may have a problem with either the receiver or the Braillenote. Please call if I can be of assistance. Carl Simmons Sendero Group Training and Technical Support 1-888-757-6810 Ext. 106 carl@xxxxxxxxxxxxxxxx -----Original Message----- From: gps-talkusers-bounce@xxxxxxxxxxxxx [mailto:gps-talkusers-bounce@xxxxxxxxxxxxx] On Behalf Of robert stigile Sent: Sunday, May 07, 2006 9:52 PM To: Mike MAY Subject: [gps-talkusers] uggestions Hello all, I am looking for some suggestions for a problem I seem to have. I cannot seem to keep the pairing with my Holux receiver. I thought that once it was paired, all I would have to do, is turn on the receiver and the braillenote, press n and then g. Well, if I do that, it says bluetooth not detected. I either have to go to the bluetooth connection, and pair the receiver everytime I turn it on, or at least, go to the bluetooth settings, and activate activesync. I was told that I might want to try reinstalling keysoft, and I did this, and it did not help. I had performed a reset, so I knew I had to go and repair, so I did this, and had the gps working great. So, then about 2 hours later, I turned the braillenote on, pressed n and then g, thinking it would just go into the gps menu, but it told me that bluetooth was not detected, so I tried going to the connections and said no to search for bluetooth and then I pressed enter on activesync, and went back to the gps menu, and it still said bluetooth not detected, so I had to go back to the bluetooth and pair it. If anyone has any suggestions as to how I can fix this, I would very much appreciate it. Thanks, Robert