[Ilugc] FSFTN] Query on eCos
- From: baskar@xxxxxxxxxxxx (Baskar Selvaraj)
- Date: Thu, 3 Apr 2014 20:33:30 +0530
Development board in the sense ? I tried to follow the steps which were
given here .
http://ecos.sourceware.org/getstart.html
1.yum install compat-libstdc++-33
2. Next to know my system architecture used
less /proc/cpuinfo and then installed the tool chain for my architecture
which was Intel X86
Hope you have used the GNU Toolchain customized for ecos (i386-elf)
which is available from the below link, and not the one which comes
with your GNU/Linux distribution.
ftp://mirror.aarnet.edu.au/pub/sourceware/ecos/gnutools/i386linux/ecoscentric-gnutools-i386-elf-20081107-sw.i386linux.tar.bz2
The next step was mentioned as
/*You may run configtool with zero, one or two arguments. You can specify
the eCos repository location, and/or
an eCos save file (extension .ecc) on the command line. The ordering of
these two arguments is not significant.
You should also set the following variable, something like
ECOS_REPOSITORY=/opt/ecos/ecos-3.0/packages/
for ecosconfig tool to work.
For running your eCos application, you may try using QEmu using 'PC
Motherboard' target.
http://www.panix.com/~grante/eCos-on-QEMU.html
Recently I conducted several workshops on 'eCos Realtime Operating
System' for M.E (CSE) students and used the following distro/tools in
the practical session.
Distribution: Fedora-20 (i386)
Additional RPM packages to be installed: qemu, tunctl, tcl,
genisoimage, xterm, compat-libstdc++-33 and some font packages (as
xterm didn't work properly due to some missing fonts)
S. Baskar
Other related posts: