Hi Carol, smiles. Me too! Pressing the blue button for
me didn't get the speech on either however a couple of
points. If you are connecting your box via the RF ariel
leads then you don't need the HDMI connector. If you
want to use the HDMI connector, then you don't need to
run the ariel cable from the box to the tv. I'd advise
using the HDMI as you'll gain the benefits of auto
switching etc.
Hope that helps
Steve
-----Original Message-----
From: access-uk@xxxxxxxxxxxxx
[mailto:access-uk@xxxxxxxxxxxxx] On Behalf Of Carol
Pearson
Sent: 08 May 2012 15:00
To: Access UK Mailing List
Subject: [access-uk] TVonics Setup Questions
Hi all,
Well, thankfully my TVonics arrived today and I've tried
setting up as follows:
My aerial cable (from outside) is in the Aerial in
socket, The other aerial socket has the aerial between
box and TV. The HDMI cable between TV and box as stated
in instructions.
It does not state in the instructions whether you need to
tune the box independently first, before putting on the
TV, so we've tried tuning both ways. On each occasion,
we've said OK to tune, since there doesn't seem to be any
other option my friend can see, and the tuning has just
gone on and on ... so we've turned off the power to the
box, given it a good 20 seconds and tried again with TV
on, but still no go!
In addition, when we first switched on, we pressed the
blue button, as speech didn't automatically come on. We
still haven't managed to get speech on as there seems to
be no bypassing the channel search.
Hopefully someone somewhere can pinpoint where we've gone
wrong, advise of anything else I can do, and we can get
up and running very soon.
Thanks for any advice for this poor novice who's never
set up a TV and box before! <Smiles>
--
Carol P
** To leave the list, click on the immediately-following
link:-
**
[mailto:access-uk-request@xxxxxxxxxxxxx?subject=unsubscribe]
** If this link doesn't work then send a message to:
** access-uk-request@xxxxxxxxxxxxx
** and in the Subject line type
** unsubscribe
** For other list commands such as vacation mode, click
on the
** immediately-following link:-
** [mailto:access-uk-request@xxxxxxxxxxxxx?subject=faq]
** or send a message, to
** access-uk-request@xxxxxxxxxxxxx with the Subject:- faq
** To leave the list, click on the immediately-following
link:-
**
[mailto:access-uk-request@xxxxxxxxxxxxx?subject=unsubscribe]
** If this link doesn't work then send a message to:
** access-uk-request@xxxxxxxxxxxxx
** and in the Subject line type
** unsubscribe
** For other list commands such as vacation mode, click
on the
** immediately-following link:-
** [mailto:access-uk-request@xxxxxxxxxxxxx?subject=faq]
** or send a message, to
** access-uk-request@xxxxxxxxxxxxx with the Subject:- faq