Thanks for bringing it to my attention. The manual was just updated, it will be fixed in the next version. On 6/19/2013 5:54 AM, Richard Bartholomew wrote:
Hi, Chris Yes, I am using 2013.3 but had missed the user.pdb file in sharedPOIs. Deleting the file has, indeed, cleared the problem and, so, I can now start creating POIs again. However, I'm slightly confused by the manual as it says that the user.pdb file is created in the folder holding maps and commercial POIs rather than in sharedPOIs. Thanks very much for your help. Regards Richard Bartholomew -----Original Message----- From: gps-talkusers-bounce@xxxxxxxxxxxxx [mailto:gps-talkusers-bounce@xxxxxxxxxxxxx] On Behalf Of Chris Grabowski Sent: 19 June 2013 10:33 To: gps-talkusers@xxxxxxxxxxxxx Subject: [gps-talkusers] Re: CREATING A USER POI Is this 2013 that you are using? Remember with 2012 and 2013 the user.pdb file is not located in maps, it is located in sharedPOIs. ----- Original Message ----- From: "Richard Bartholomew" <richard_bartholomew@xxxxxxxxxxxxxxxx> To: <gps-talkusers@xxxxxxxxxxxxx> Date: Wed, 19 Jun 2013 10:27:59 +0100 Subject: [gps-talkusers] Re: CREATING A USER POIHi, Thanks for the suggestions but, unfortunately, I don't have a user.pdbfileas one has never been created by the process. I have tried creating an empty file to see if this would help but it doesn't! Also, my initialsarein the author field, ie rlb. Regards Richard Bartholomew -----Original Message----- From: gps-talkusers-bounce@xxxxxxxxxxxxx [mailto:gps-talkusers-bounce@xxxxxxxxxxxxx] On Behalf Of Chris Grabowski Sent: 19 June 2013 10:25 To: gps-talkusers@xxxxxxxxxxxxx Subject: [gps-talkusers] Re: CREATING A USER POI Hi, Try and rename your user.pdb file and try again, perhaps it is bad. Also make sure your POI author name is set correctly. IE it has characters and isn't just a space. On 6/18/2013 1:07 PM, Richard Bartholomew wrote:Hi, Mike Thanks for reply and hope you have a great day zip lining - sounds likesomegood fun! Yes, I have tried creating a POI without adding media but still get thesameresults, I'm afraid. Regards Richard Bartholomew From: gps-talkusers-bounce@xxxxxxxxxxxxx [mailto:gps-talkusers-bounce@xxxxxxxxxxxxx] On Behalf Of Michael May Sent: 18 June 2013 18:03 To: gps-talkusers@xxxxxxxxxxxxx Subject: [gps-talkusers] Re: CREATING A USER POI Richard, Have you been able to create a user POI without media? Normally, onepressesSpace with dot 3, enter the name and category and click through tofinish.If you want to add a media clip, you can do so on the BrailleNote butnotthe Braille Sense. Also, to change the category on the Braille SensefromUser Private to Public or another category like Restaurant, you need tousethe Modify button after the Point is originally created. The User.pdb file will be created once you record your first point. Then remember to use Sendero Maps to share your points with others. Off to do some zip lining today. Mike From: gps-talkusers-bounce@xxxxxxxxxxxxx [mailto:gps-talkusers-bounce@xxxxxxxxxxxxx] On Behalf Of RichardBartholomewSent: Tuesday, June 18, 2013 11:46 AM To: gps-talkusers@xxxxxxxxxxxxx Subject: [gps-talkusers] CREATING A USER POI Hi, For various reasons, I've been virtually housebound for the past fewmonthsand, so, have not had the need to do this but, over the past week, Ihavebeen trying but without success! I am using version 2013.3, Build 499onanApex BT32. I appear to be following the steps laid out in the manual but every timeIget to the final one, ie "Add Media File", and hit enter on either"None"(my preference) or "Description", I get the message "operationcancelled"!I have tried this numerous times (including after reboots) but still the same problem. The user.pdb file does not exist anywhere and definitely not in mydefaultdirectory for maps and POIs. The storage device I'm using is not write-protected and I have been able to create files on it via othermeans.Anyone got any ideas, please, as I know I'll be doing something fundamentally and stupidly wrong! Thanks in anticipation. Richard Bartholomew _____ No virus found in this message. Checked by AVG - www.avg.com Version: 2013.0.3345 / Virus Database: 3199/6419 - Release Date:06/17/13-- Twitter: MysticAccess To change your email settings (unsubscribe, digest only, or vacationmode):http://senderogroup.com/social_media/email.htm Additionally, to unsubscribe send an email to gps-talkusers-request@xxxxxxxxxxxxx with "unsubscribe" in the Subject. To change your email settings (unsubscribe, digest only, or vacationmode):http://senderogroup.com/social_media/email.htm Additionally, to unsubscribe send an email togps-talkusers-request@xxxxxxxxxxxxx with "unsubscribe" in the Subject.To change your email settings (unsubscribe, digest only, or vacation mode): http://senderogroup.com/social_media/email.htm Additionally, to unsubscribe send an email to gps-talkusers-request@xxxxxxxxxxxxx with "unsubscribe" in the Subject. To change your email settings (unsubscribe, digest only, or vacation mode): http://senderogroup.com/social_media/email.htm Additionally, to unsubscribe send an email to gps-talkusers-request@xxxxxxxxxxxxx with "unsubscribe" in the Subject.
-- Twitter: MysticAccess To change your email settings (unsubscribe, digest only, or vacation mode): http://senderogroup.com/social_media/email.htm Additionally, to unsubscribe send an email to gps-talkusers-request@xxxxxxxxxxxxx with "unsubscribe" in the Subject.