You can use R, A and then E to determine the remaining distance in your route once you create it. For example, if I enter the address of my place of work, and press the letter D or Dot6 for Destination, it is 18.05 miles to the South as the crow flies. If I press the letter R, then V to create a vehicle route, and then press D for Destination, it is still 18.05 miles to the South. But you can then check the actual route distance as follows: Press the letter R for Route commands. Press the letter A for Route Announcement command list. Press the letter E for Remaining distance in route. By pressing R, A and then E, I see that the actual driving distance is 27.21 miles. The same method works for both vehicle and pedestrian routes. From: gps-talkusers-bounce@xxxxxxxxxxxxx [mailto:gps-talkusers-bounce@xxxxxxxxxxxxx] On Behalf Of tbrowngriffin@xxxxxxx Sent: Saturday, April 17, 2010 11:25 PM To: gps-talkusers@xxxxxxxxxxxxx Subject: [gps-talkusers] distances help pease Hi My Pk always comes up with wrong distances from point A to point B, for example, when I create a vehicle route to Sheffield which is approximately 221 miles it tells me It is 187 miles, is it calculating as the crow flies or have I somewhere got settings wrong? The example about is just one, but it is in both pedestrian, vehicle and other so is at least constant! I find it misleading as I walk a lot and will often look at distance before I decide on modes of transport, but when calculating how much time I have before a meeting I need a more accurate distance to know how long it would take me to walk a route, hope that makes sense! I guess if there is no way to change the setting I will just have to put up with it and take it as one of it's quirks! Thanks in advance Tony