There's also miniature 1/4-28 compression fittings with the same o-ring face
seal design. I assume the thru hole would be larger than the #10-32 ones.
-Bob
On Dec 22, 2015, at 21:07, Paul Breed <paul@xxxxxxxxxx> wrote:
Its made of aluminum....
How small can you get AS-5202 fittings?
I've used the 10-32 fittings and the flow path is just slightly maginal for
the fuel...
On Tue, Dec 22, 2015 at 6:19 PM, Ben Brockert <wikkit@xxxxxxxxx> wrote:
Parker has a line of male AN fittings that include a teflon seal in
the 37 degree face. I expect it's possible to print one. I haven't had
the chance to prove it yet.
Anodizing the part will help make it possible, in addition to making
the regen portion a lot easier.
On Tue, Dec 22, 2015 at 8:05 PM, Paul Breed <paul@xxxxxxxxxx> wrote:
Looking for suggestions on how to terminate fluid and pressure sensor
connections in a 3D printed chamber.
The blobs of metal for the fuel connection and the chamber pressure sensor
are significant parts of the chamber weight.
https://pbs.twimg.com/media/CW3wUbqUAAA5Ciu.jpg:large
this is the flight weight chamber fully accounted including cat pack lid
and
internal parts will have a
thrust to weight of > 110
Paul
