We've also used them for vacuum cryo plumbing at Altius, where we needed to
pass LN2 into a reasonably high vacuum environment (10^-5 Torr), and so far
haven't had any problems with swagelok fittings when used correctly.
~Jon
On Tue, Jul 12, 2016 at 10:52 AM, Michael Clive <clive@xxxxxxxxxxx> wrote:
Used em for years in deep cryogenic applications, bubble tight at 6k
helium on half inch lines
On Jul 12, 2016 11:02 AM, "Kyle Meeuwsen" <meeuwsen.engr@xxxxxxxxx> wrote:
Thank you very much!
Best,
Kyle
On Tue, Jul 12, 2016 at 7:39 AM, David Gregory <david.c.gregory@xxxxxxxxx
wrote:
Or buy them already cleaned from swagelok, if it fits your budget.
On Jul 12, 2016, at 4:11 AM, Robert Watzlavick <rocket@xxxxxxxxxxxxxx>wrote:
Just be sure to clean all the pieces for oxygen use.
Swagelok fittings in stainless, brass, or aluminum are fine for LOX.
wrote:
-Bob
On Jul 12, 2016, at 00:08, Kyle Meeuwsen <meeuwsen.engr@xxxxxxxxx>
application? Just making sure.. A quick check on the internet provided
Hello All,
Quick question - Are swagelok fittings acceptable for cryogenic (LOX)
nothing.
Thank you all again for all of the help so far.
Kyle Meeuwsen
Portland State Aerospace Society