Beal’s side of the story.
https://www.beal-aerospace.com/
Anthony J. Cesaroni
President/CEO
Cesaroni Technology/Cesaroni Aerospace
http://www.cesaronitech.com/
(941) 360-3100 x1004 Sarasota
(905) 887-2370 x222 Toronto
From: arocket-bounce@xxxxxxxxxxxxx <arocket-bounce@xxxxxxxxxxxxx> On Behalf Of
Anthony Cesaroni
Sent: Friday, October 1, 2021 10:53 PM
To: arocket@xxxxxxxxxxxxx
Subject: [AR] Re: Introduction to Aphelion Aerospace and a new RGHP system
I didn’t know that. I was under the impression that FMC was the supplier and
there were a lot of politics involved.
What happened to all the hardware that was built?
Thanks.
Anthony J. Cesaroni
President/CEO
Cesaroni Technology/Cesaroni Aerospace
http://www.cesaronitech.com/
(941) 360-3100 x1004 Sarasota
(905) 887-2370 x222 Toronto
From: arocket-bounce@xxxxxxxxxxxxx<mailto:arocket-bounce@xxxxxxxxxxxxx>
<arocket-bounce@xxxxxxxxxxxxx<mailto:arocket-bounce@xxxxxxxxxxxxx>> On Behalf
Of roxanna Mason
Sent: Friday, October 1, 2021 10:50 PM
To: arocket@xxxxxxxxxxxxx<mailto:arocket@xxxxxxxxxxxxx>
Subject: [AR] Re: Introduction to Aphelion Aerospace and a new RGHP system
Yes I do Anthony, it was death by 1000 cuts because they manufactured their own
HTP in house which put an unnecessary strain on their resources which otherwise
could have been eliminated with an OTS propellant. At least their hydrocarbon
fuel was OTS.
Ken
On Fri, Oct 1, 2021 at 7:34 PM Anthony Cesaroni
<anthony@xxxxxxxxxxx<mailto:anthony@xxxxxxxxxxx>> wrote:
Hi Ken,
Do you believe the choice of the oxidizer was a contributing factor? If so, how?
Thanks.
Anthony J. Cesaroni
President/CEO
Cesaroni Technology/Cesaroni Aerospace
http://www.cesaronitech.com/
(941) 360-3100 x1004 Sarasota
(905) 887-2370 x222 Toronto
From: arocket-bounce@xxxxxxxxxxxxx<mailto:arocket-bounce@xxxxxxxxxxxxx>
<arocket-bounce@xxxxxxxxxxxxx<mailto:arocket-bounce@xxxxxxxxxxxxx>> On Behalf
Of roxanna Mason
Sent: Friday, October 1, 2021 9:43 PM
To: arocket@xxxxxxxxxxxxx<mailto:arocket@xxxxxxxxxxxxx>
Subject: [AR] Re: Introduction to Aphelion Aerospace and a new RGHP system
For most uses, though, torch
igniters seem quite satisfactory.
I second that with >1000 successful torch ignitions under my belt.
Years ago I turned down a job with Beal Aerospace because he wouldn't budge
from HTP as his main/only oxidizer.
When I suggested he think about alternative oxidizers like LOx, he nearly got
angry. With such a closed mind attitude I felt the company's days were numbered.
The rest is history.
Ken
On Fri, Oct 1, 2021 at 1:20 PM Norman Yarvin
<yarvin@xxxxxxxxxxxx<mailto:yarvin@xxxxxxxxxxxx>> wrote:
On Fri, Oct 01, 2021 at 11:58:10AM -0700, Matthew Travis wrote:
... a new “green” non-toxic and environmentally-friendly hypergolic
bipropellant in an operational system. This will enable very low
system cost, minimal infrastructure requirements and low launch
costs. A lot of our tech is proprietary but I can say that our
oxidizer uses RGHP and the fuel is NOT petroleum-based (e.g. RP1,
Kerosene, etc.).