[AR] Re: Mills Fuel Experiment
- From: "Monroe L. King Jr." <monroe@xxxxxxxxxxxxxxxxxx>
- To: arocket@xxxxxxxxxxxxx
- Date: Thu, 19 Mar 2015 18:35:42 -0700
HHO practically insures an overunity experiment because the bond of
water is just too strong to indicate anything else!
Monroe
> -------- Original Message --------
> Subject: [AR] Re: Mills Fuel Experiment
> From: James Bowery <jabowery@xxxxxxxxx>
> Date: Thu, March 19, 2015 6:24 pm
> To: arocket <arocket@xxxxxxxxxxxxx>
>
>
> Please provide a link to the derivation of this over-unity implication.
>
> On Thu, Mar 19, 2015 at 8:13 PM, <qbert@xxxxxxxxxxxxxxx> wrote:
>
> > I'd be very speculative of his work, although he's never said it
> > publicly, if you follow his line of thinking you get an over unity device.
> >
> > At 06:57 PM 3/19/2015, you wrote:
> >
> > For those willing to entertain a speculative fuel -- one which has a
> > potential exhaust velocity (specific energy) of tens of km/s:
> >
> > Reading H2O-Based Solid Fuel Power Source Based on the Catalysis of H by
> > HOH Catalyst
> > <http://www.blacklightpower.com/wp-content/uploads/papers/SunCellPaper.pdf>Â
> > and thinking about what might constitute a relatively simple and
> > inexpensive qualitative demonstration, it occurs to me that if (as is
> > indicated by Table 1) titanium is acting as a Mills catalyst, a pure Ti+H
> > system based on atomic hydrogen welding (AHW) may be worth a try for the
> > following reasons:
> >
> >
> > - In AHW, the shielding gas is hydrogen.
> > - The tungsten electrodes could be replaced by titanium electrodes
> > feeding in at a higher rate.
> > - Rather than nano-titanium the catalytic surface is vaporized
> > titanium at 3,287°C -- a temperature readily achievable by AHW.
> > - Being shielded from oxygen by the hydrogen flow, titanium oxidation
> > is avoided thereby avoiding a major confounding process and variable.
> > - The power into the AHW apparatus therefore takes two easily
> > meterable forms:Â
> > - electric power from the wall andÂ
> > - hydrogen gas
> > - The power out of the AHW apparatus should be dominated by light,
> > which is also easily meterable.
> > - Finally, and perhaps most decisively, the peak temperature should
> > exceed that achievable by AHW.
> >
> >
> > Further on in the same paper, Figure 10 may indicate a superior fuel
> > mixture of:
> >
> > 50 mg NH4NO3 + KOH + KCl (2:1:1 wt.) + 15 mg H2OÂ
> >
> >
Other related posts: